Granada Spindles - Ford Motor Forums

tbolt · #1 (**permalink**) 02-27-2004, 04:41 PM

Looking for spindles off a 75 -80 Granada or Mercury Monarch.

yblockv8 · #2 (**permalink**) 03-23-2004, 10:01 PM

i used those spindles for a disc brake swap on my 56 ford i found mine at the local junk yard but there is a company that i think sells them they are called fatman fabrications

tbolt · #3 (**permalink**) 03-24-2004, 06:49 PM

Welcome to the forum yblockv8. Thanks for the info. I too am doing disc brake conversions on early Fords. I have tried local salvage yards and anything over 15 years old gets crushed. I even tried looking to buy complete cars and nothing to be found. I have dealt with Fatman Fab. before and must say they are excellent but did not know they sold Granada spindles. For $60 you get reworked spindles dropped 1" from factory, COOL!
Thanks again

Allan

yblockv8 · #4 (**permalink**) 03-24-2004, 09:35 PM

thanks. I also used everything , from the granada, for the swap but i bought it new ,booster, master cylinder, caliper, rotor and it wasnt to expensive after everything it was about 400 dollars but the spindles had to be machined to fit on the lower ball joint. it still wouldnt fit all the way but we put a spacer in between and it worked but it did lower the front about an inch. let me know if you need any more info

dustin

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode	Rate This Thread: