I thought I'd start a thread on the work I'm doing to my Ranger. Since this truck is an ongoing work in progress I felt this would be a good way to chronicle my progress.
I also felt that for those of you that want to follow my progress, it would be easier if all the photos were in one thread. Instead of scattered throughout the forum as they now are.
My truck is a 2002 Ranger XLT, 3.0L, automatic, extended cab, 4 door. The engine has been "warmed up" a bit with a K&N cold air intake, Granatelli Mass Flow Sensor,
SuperChip programmer set for 87 octane mileage. I can also program for 91 & 93 octane performance when I'm in the mood to play.
Magnaflow cat back exhaust system with single 2.25" in/dual 2.0" out the rear of the truck into 4 Gibson rectangular chrome tips .

My ranger about a week after I purchased it in 2002.
I had already installed the CB you see in the photo below. -----------------------------------------------My first upgrade. An A.R.E. hard tonneau cover.



My first audio upgrade. A Kenwood MPV 619 H/U. (this will be replaced this fall by a Pioneer AVIC-N3
In-dash DVD receiver with navigation and 6.5" video screen.) I'm mainly after the navigation part. My sense of direction sucks.
This was followed about a year later with a 10" JL sub, MTX amp and a Kenwood 6 CD changer you see on the right.



About 2 years ago I lowered the truck 2"Front/3"Rear. ---------------------------------------------------- Then I added 18" Baccarat wheels and 235/50 GoodYear Eagles'.


New front end. Cowl induction hood, bumper cover with fog lights,
upper and lower Speed grills. ----------------------------------------------------------- Roll pan, tailgate cover with handle removed, spoiler.
----------------------------------------------------------------------------------------------Note 3rd brake light removed from roof of cab and placed in spoiler.